Manual Reset by pressing RESET key OR Remote Reset from back side terminal i.e. short IP1 with +V Terminal.
To start the time totalizer function i.e. short IP2 with +V on rear terminal
Manually press HOLD key for one second till display flashing "HoLd".
To release Hold, press again HOLD key then â€˜rESUnâ€™ will come on display
indicating hold is released.
Second/ Minute/ Hour range from 1-999999 (6 digit) programmable by users.
Minute - Second range from 0000.01 to 9999.59.
Hour - Minute range from 0000.01 to 9999.59.
Hour - Minute- Second range from 00.00.01 to 99.59.59.
1,0.1,0.01 (programmable) for Sec / Min / Hour.
Better than 0.1%
11.059 MHz quartz crystal time base.
6 digits L.E.D display for Time Totalizer function.
8 L.E.D. for RL1 , RL2, TX, RX, SET, HOLD, INPUT & CLK
By 3 membrane keys on front panel
Count Up / Count Down user selectable.
Normally ON, Normally OFF, Pulse output with relay ON / OFF time from 0 to 999.9 second.
1NO/C/NC relay potential free contact rated 250VAC / 5Amp for RL1 & RL2.
+12 VDC, 50mA supply for proximity, infrared sensor, buzzer etc.
230 V AC 10% 50 Hz OR 110 V AC 10% 50 Hz OR 24VDC.
Panel mounting / Wall mounting for Flameproof model.
96 (W) X 48(H) X 120(D) in mm. OR 72 (W) X 72(H) X 120(D) in mm.
92(W) X 44(H) in mm. OR 68(W) X68(H) in mm.
'L'type connector for 'Y'type Lugs.
1) Isolated RS485 Serial port with MODBUS RTU Protocol output for PC interface. Powerful SCADA Software is available.
2) Flameproof version is available on request for hazardous application.
1Kg. / 1.5Kg (Aprox.)